by XcrismonP
This is Ceadeus from Monster Hunter Tri. I made this underwater elder dragon in few hours during the sculpt january 2019 deep sea challenge. To make it easier to print, I split it in two and glued it together later. Since this monster is a underwater moster, I made a stand for it so it could stay in pose.
Printer Brand:
Duplicator 4
Printer:
Rafts:
No
Supports:
Yes
Resolution:
0,2 mm
Infill:
10%
Filament: Clas Ohlson PLA white
I glued the two pieces together using superglue and then started to paint it. The paintjob was very hard and I'm not super happy with the result, but I had to call it finished since i could not get it how i would like it to look.
