by nestechs
This is my remix of the awesome work that Killonious did. I just took his print and cut out for a PVC pipe and scaled the print up to 275%. I did have to shave a little of the PVC pipe to get it to fit the bottom. I think I used 1 and a half inch PVC. I had to dig back thru and find my edits that I made but these should work if you want to print a Rainbow Smash for cosplay. I added some 1mm foam for details. I also had to print the eyes because the ones that were on the main print fell off.
Printer Brand:
Creality
Printer:
CR-10S
Rafts:
No
Supports:
Yes
