by cyclone, published
I didn't notice there was already a version of this in one piece, apologies. But since this version is different I decided to post it anyway. The two pieces of the coin put together, one version standing with a flat on the bottom. Works well with a raft, which if you left a bit in place after clean up, makes up for the flat. Printed fine at .075mm layer height.
Model has the same detail thickness as the original.
"2 Skull" version has the skull on both sides TwoFace style.
There is also a necklace version.
Print standing up with a raft. It might work without a raft but there is a fairly small area stuck to the table so failure is very likely without one. Standing the model up takes advantage of the higer z resolution so I recommend a low layer height. These were printed at .15 layer with skin half that height at .075mm.
Be cursed, until you can get the gold to Isla de Muertos.
