by VolcanSquid
This is a model of the Kensa Luna Blaster from Splatoon 2. I tried to get everything as accurate as possible, and if any of you have beef with me over not doing something right, I will fix it :)
The assembly is quite straight-forward, and the only issue I found was in the Black bulb. Just make sure It isn't leaning too far away from the mouth, and its in the right spot.
This took me a total of about 36 hours to print at a 0.1mm layer hight off my Monoprice select Mini with AmazonBasics PLA, but im sure it will work fine with other layer heights and plastic types.
Happy Printing!
Printer Brand:
Monoprice
Printer:
Select Mini
Rafts:
Doesn't Matter
Supports:
No
Infill:
12% at least, for main body
Filament: I used Amazon's AmazonBasics filament PLA In black and white
Notes:
The only place where you would want supports is on the bottom of the black bulb, just so it has enough surface to not knock off the build plate.