by chris_guicha
This is a 3 part wedding caketopper, around 140mm tall, cutted in half for reduce printing time and material in supports, modeled in Zbrush, Fusion 360 and cut in Meshmixer.
Enjoy!!!
Printer Brand:
Creality
Printer:
CR-10S
Supports:
Yes
Resolution:
0.1
Infill:
20%
Filament: Hatchbox PLA Black
Notes:
Tips for printing:
-Block with 100% infill in the thinnest parts such as tails and snouts.
Tips for post-printing:
-A little bit of sanding on keys to ensemble.
-You can spray with sand finish to a better good looking.
-You can attach the part C(Heart) with cyanoacrylate glue.
