by Ultor3

Print Settings

Printer Brand:                          

Anet

Printer:                          

A6

Rafts:                          

Yes

Supports:                          

Yes

Resolution:                          

0.1mm

Infill:                          

15% most parts, 30%torax and abdomen, 100% head, horn, jaw, hands

Filament:                                            several (this uses a lot of filament - at least 220g) ABS, PLA                                        blue/ dark blue                                        

Notes:

-definitely get a whole reel of blue filament first as it's cheaper than per 100g, this model is big and uses a lot of it.
-do not sand balls unless necessary, they can be really loose
-it's big, about 30cm
-print smaller bits like horn or jaw one at a time as they may fail easily due to unsticking
-shoulder guards are press-fit and can need some sanding of them or shoulder to get on completely
-it is a very bad idea to start a print with a ball due to low contact area, balls come out way better and the print unsticks much less if they  are pointing up or sideways rather than down, abdomen being an exception as it has a big ball with a flat zone it can stand on.
-printing parts with the least important side facing down, like the side that will be glued or the side facing inwards produces less conspicuous support separation areas, so less grinding is necessary.