by T1ckL35
Couldn't find a T-70 in 15mm scale so took the 2 sources. The 1:56 original had areas that were too thin to print (mainly the tracks and the track covers) so grabbed the 1:200 source, thinned the relevant bits and dropped it into the mesh.
I think the guns on the turret might need thickening and the smaller details thickening too but this should be good enough for my need of T-70 tanks for an upcoming Stalingrad Crossfire campaign :)
Printed the hull without the turret insert so once I have the tracks and turret printed it will need to be done again. I'll then add pictures here.
Printer Brand:
Creality
Printer:
Ender 3
Rafts:
No
Supports:
Yes
Resolution:
0.08 to 0.2
Infill:
various
Filament: Generic PLA Red
