by gregadamson
This is a laser line scan object from 20 years ago, cleaned up and repaired. It is not easy to print. I found that if printed on his back, as suggested by Meshlab, with lots of support, he turns out very well. The little one was printed at 50% size and .1mm layers, the larger at 70% size, .2mm layers. I used 3 outline/perimeter shells to help with nearly horizontal areas.
There are lots of dragons in the thingiverse but none as cute as this.
Printer Brand:
Anycubic
Printer:
Kossel
Rafts:
Yes
Supports:
Yes
Resolution:
.2mm or .1mm
Infill:
20%
Filament: 3d solutech pla clear
Notes:
Challenging to print.