by XThunder50
Hi there.
I liked the original file design of Saitama, but it was not supposed to be printable because of major geometry errors inside the model.
So, after acknowledging it, I decided I wanted to make it work and maybe I'll print it too in the future.
The first issue were the geometries on the legs, that would cause wide emtpy parts inside and it would cause the print to fail or it would make that section extremely weak and prone to break.
A second little issue was a wrong geometry near the neck.
A third issue was the base. I partially corrected it to have a working base, but to finally fix this you have to move the Z coordinate of the model to -0.32 in the slicer, it will make the base completely flat.
Then I fixed some minor geometries errors in the model.
Enjoy, and let me know your appreciation if you print it successfully!
Printer Brand:
Creality
Printer:
CR-10S
Rafts:
No
Supports:
Yes
Resolution:
0.04 (0.12 layer height)
Infill:
20%
Notes:
IMPORTANT: Set the Z coordinate to -0.32 in the slicer when printing this model at 100% scale, so the base will be flat.
