by PeterG71, published
I printed the original model earlier this year and was very happy. As I've learnt more about the design software and 3D Printing I've wanted to put more detail into this model. I've been using stills from a recent eBay auction for one of the original Liberators from the BBC so have been able to verify some of finer design details. I'd like to say this model would not have been possible without zeframs work on the original. I've included all parts in this list to make a Liberator, if it doesn't say 'new' its directly from zeframs model. Many thanks again for your design.
I hope you have fun printing this, the engine lines are done using white filament which fits in the holes and groves in the new model. It's a bit fiddly but definitely sets the model off.
I printed the nacelles in 10% infill otherwise they can get quite heavy and not hang right off of the fuselage.
To print you will need:
1 each of all of the Fuselage sections
2 engine globes
3 each of all of the Nacelle sections
3 struts
19 pins
1 stand
Some white filament for the engine
