by Bountyhunterxx5

See the "Usage and Disclaimer" section for important information regarding this model.

Yoda "Quickly now, Reach the planets surface we must."
Republic envoy: "In an escape pod sir? The enemy will fire at anything we launch."
Yoda: "Then launch all of them, you will."
Star Wars: The Clone Wars - S1 EP1

This model is based on the Republic escape pods feature in the animated series Star Wars: The Clone Wars. There are a few versions of the model, the terminology of which is explained below:

• Cockpit: The front of the model which attaches to the Body.

• Body: The complete back half of the model.

• (Cable clamps): Versions with this designation have small tabs that connect to cables located are around the body.

• Crashed sideways: This version is cut down the middle at a 7-degree angle and lays flat.

• Crashed vertical: This version cuts the cockpit off the model at a 20-degree angle so the back half sticks out of the ground.

As always, if you print one please post a make, I'd love to see how it turned out and get any feedback you may have. Happy Printing!

Print Settings

Printer:                          

CR-10

Rafts:                          

Yes

Supports:                          

Yes

Resolution:                          

0.12mm

Infill:                          

18%

Filament:                                            Dikale PLA                                        White                                        

Notes:

I printed with supports everywhere to be safe, however, it's up to your discretion.

Usage and Disclaimer

The end-user may:

• Print as many copies of this model as they wish

The end-user may NOT:

• Claim that they designed this part

• Sell the .stl files or any other files associated with this model

• Sell printed versions of this model without my explicit consent.

Disclaimer:

• I am in no way affiliated with or endorsed by Disney, Fantasy Flight Games, Lucasfilm, Lucasarts, EA or any other stakeholders in the Star Wars franchise. I make no claim to any of the original designs my models are based on.

• I am not responsible for what you do with these parts once you download them, and the end-user assumes responsibility for upholding the associated license once they download this part.

• I reserve the right to change the license at any time, and it is the responsibility of the end-user to ensure they are aware of the license and what it entails.

• The end-user assumes responsibility for anything that occurs when printing this part (i.e. if your printer breaks while printing this It's not my fault). I suspect this won't be an issue for anyone but you never know.