by cheesiosaur
First attempt at 3D modeling - picked a monster from DND that I wanted and went from there. It likely has a few issues, but printed fine for me on an Anycubic Photon.
The raised left front leg is a bit... wrong, which I might go back and fix at a later date.
Printer Brand:
Anycubic
Printer:
Photon
Rafts:
Doesn't Matter
Supports:
Yes
Notes:
I printed this on a Photon angled backwards until the tongue was pointing straight up. I suspect that some of the details (such as the claws) won't print on FDM without a tiny nozzle and perfect calibration.
You may need to scale this up 1000% (10X) as I think it's quite likely scaled off due to misplacing a decimal... base should be 25mm once scaled properly, then scale the creature by the same multiplier used to scale the base properly.
Once attached to the base the tail should hang off the back slightly but not touch the table, as in the photo.
