by Biba666
This is my remix of Audrey2.
I found it rather difficult to print the original version without using alot of support.
It also didnt fit my printer, but I wanted to do a really big version.. so..
I've used meshmixer to cut off the head, leaves and tentacles to print them separately, also I've put in pins to make everything reattachable without much effort.
I've also included an even easier version, where I've split every piece again to lay it flat on the bed. Choose what fits you best. ;-)
To get a plant as big as mine, you need to scale everything up to 250%. The pins might be a tight fit, scaling them to 240% worked out fine for me.
Supports:
Yes
Resolution:
0.16
Infill:
15%
Filament: Redline PLA
