by CdRsKuLL
Hopefully, these will help fellow car enthusiasts.
I run the Extreme kitcar owners club ( www.extremeoc.co.uk ) and decided to design these up in the hope others will find them useful.
If you haven't got a 3D printer then I can offer my 3d printing services at www.quick3d.co.uk
I would advise printing these in PETG or ABS due to the heat that they may incur being embedded within the headlight. PLA would not be suitable as it will go soft. No support needed at all when printing.
Thanks,
Steve
Supports:
No
Resolution:
0.2
Infill:
20%
Filament: Any PETG, ABS NOT PLA
