by DeVereor
I edited mushroom heads to work in vase mode, and made a round pot and soil.
Sorry messy, new to 3D software (Blender).
No idea why, but Head.stl doesn't keep it's sizing and i cannot remember it.. I advise getting the original and scaling Head.stl to fit the size of them.. Printing one at a time, one big two small.
Pot scale so Z is 43.65
Below are the settings i used on my Ender 3 Pro to print this.
after printing i sprayed heads with filler primer, sanded, and sprayed again. and sprayed pot with standard primer.. just because made colours i wanted.
Stems i put into one Print close together to avoid travel
white PLA
Top 4
Bottom 4
Shells 3
Layer .1
infill, support, rafts 0
Speed 5200
Mushroom Heads i printed in vase mode
used wood PLA as initially wanted them and the soil to stay that colour
Layer .15
Speed 4800
Soil
Wood PLA
Layer .2
Infil 15%
Speed 5200
Pot
White PLA
Top 4
Bottom 4
Shells 5
Layer .2
infill, support, rafts 0
Speed 5200
