by invitedchaos

Remix of BlueGecko's DE-10 blaster. I wanted to use the standard frame and add an actual scope, so I just split it off and left the flat for a frame mount location. Can also be used as-is. The two sides are identical, just mirrored for ease of use.

11/15/2019: Test printing right now, so I can't speak to the end results just yet, but if you trust the skill of strangers on the internet, feel free to use it at your own risk. I'll post the print photos in a couple days and adjust if necessary.

Unscaled the thing is huge (probably two feet long when assembled; I imported it into 3D Builder on the wrong scale), so make sure to adjust as necessary when you slice. I'm testing at 65% for a women's large/men's medium hand size (should give a 2.5-2.75" long grip on the side you wrap your fingers around).

Print Settings

Printer Brand:                          

Creality

Printer:                          

Ender 3

Rafts:                          

Doesn't Matter

Supports:                          

No

Resolution:                          

0.2mm

Infill:                          

20%

Filament:                                            3D Hero PLA                                        Black                                        

Notes:

Print speed: 60 mm/s
Wall speed: 30 mm/s
Print Temp: 210*C
Brim width: 10 lines, outside only
Estimated print time: 12hrs 14min
Estimated material: 120g or 40.39m

All other settings are recommended Cura slice defaults.