by mrduck123
If you want to see what else is in the works, follow my instagram! @wiseprints206
This is my revolver winchester! when you pull the lever, the revolver rotates! It is completely 3d printed with no extra pieces you need to buy!
Iv'e been holding off on posting this model for a while because it isn't finished, but I don't know when I will get back to it so I figured I would post it. The only part to be completed still is the trigger. Everything else works, gears, ratchets and all. I really wanted to make a model that was 100 percent 3d printed without any other pieces, so anyone can print it and build it. I ran into an issue however on trigger design, as I struggled to come up with a mechanism that would click the trigger when you pulled it. Especially with the limited space available. I'll finish this when I think of a good trigger design that consists of only 3d printed parts! Until then, have fun printing this!
Note: print the internals and gears with 60% or more infill, and really high detail for best performance, everything else can be lower detail.
