by Pawpawpaw85, published
Created a corner protector due to several accidents involving injuries to the legs/feet from sharp edges of furniture.
This corner protector got a base of 50mm, and a spherical outside that almost tangents the sharp edge that you do not wish to bump against.
It screws into the wood with 2 screws (approximately diameter 4mm) to secure it to the furniture as a (semi)permanent solution.
Girlfriend still bumps against the corner sometimes, but not even a bruise anymore :)
Part should be printed in ABS or PET-G for maximum durability.
Print with support on, remove support and sand the spherical side to get a smooth finish.
