by redreplicant
A replica of the Old Scituate lighthouse in Massachusetts, made for my reddit secret Santa. It has a full set of spiral stairs inside of it, but you won't be able to see them if it prints out correctly.
I highly recommend printing it without supports. The only touchy area will be the lantern on the top, but if you keep an eye on it and have your settings pretty dialed in, it should bridge fine.
You may want to increase the shell thickness a bit due to the windows. I also uploaded two versions here because the pillars in the lantern are very delicate. The earlier one has correct (slender) pillars and the later one (12/15) has lengthened pillars that are less likely to be knocked over by your extruder.
Printer Brand:
LulzBot
Printer:
Supports:
No
Resolution:
.11
Infill:
20
