After buying a few Boba helmet files and them not being up to par I took it upon myself to create a good rendition with the intent of it being able to get 501st approval. I love Raff Fett's helmet but his files are too low poly and sanding takes forever as Ive built one of his helmets.
This Helmet Follows a similar build style.
To complete it you will need:
A few 4mmx1mm round neyodimium magnets to make the range finder and ear cap stay in place.
2 5mm red LEDs for the RF (use RF hollow if you wish to add electronics)
Raff Fetts MQ-1 circuit board (This is optional for a prop but is required for 501st)
This is under no means alowed to be replicated and moulded for profit, this is a free product made with the intent for everyone to have access to a high quality free boba fett helmet.
Check out my other designs and projects here: https://www.facebook.com/ChrisThePropGuy-1445080005542643/
Printer Brand:
Creality
Printer:
CR-10
Rafts:
No
Supports:
Yes
Resolution:
.02
Infill:
100%
Notes:
I reccomend printing helmet upside down to reduce support
