by Pr0nboy

This was one of the first projects I made in Blender for cosplaying. Unfortunately, I ended up not using it, so I uploaded it with the hope that someone could bring it to life and actually use it. I'd like to make some remarks:

• This is not as finished as I'd like it to be, it lacks some test and correction. Even with that I think it is perfectly useful with some post-proccessing. See the print settings section

• Its piercing power is impressive, be careful

Print Settings

Printer Brand:                          

Creality

Printer:                          

CR-10S

Rafts:                          

No

Supports:                          

Yes

Resolution:                          

0.2

Infill:                          

30

Notes:

I really didn't test this out properly, I only made 2 prints of the full pack and made little corrections to the model.

• The image one is like at 125% size of the model I uploaded because it came out too big

• The T's union between edge and handle may not be strong enough to support the stress and break. If able, I'd recomend strong filling for that part.  Even with that union broken, the edge and handle should fit quite well

• I recommend the use of supports, specially with the handle part

• The detail part may be a little tricky, sandpaper treatment may be needed for it in order to fit with the handle

How I Designed This

Just blender

Custom Section

Print at 125%

Print at 125% with beautiful young male hand as refference