by mixonsr
My daughter likes carved cow skulls and dream catchers, I combined the two for a Christmas gift.
I used "snowflake 8 sides" by Trigubovich, feather by octomo and blue wildebeest by p3ddp
The skull was printed in two parts, basically sliced horizontally. I did this using Simplify3D. Used Z offset to create a top half of the skull and printed with supports. Then rotated 180% and printed bottom half. I am sure there are many other approaches.
I added square pins to the horns and matching sockets on the skull to make glueing easier.
Printer:
MakerGear M2, its just great
Rafts:
No
Supports:
Yes
Resolution:
Medium for the top half of the skull, low for the rest
Infill:
12%
Filament: Hatch PLA Black
