by truedrewblue
This is very much a prototype, we don't have the exact dimensions yet so this is just me going off of rough shapes in a few clips and other models. The two pieces used to connect the components print tight so I would print those slightly smaller but not too much. This is also the first model I've made for this website so if you like please show your support.
Printer:
SnapMaker
Rafts:
Doesn't Matter
Supports:
Yes
Resolution:
I did .2mm
Infill:
I did 8% but it depends how strong you need it to be.
Filament: Hatchbox PLA Black
Notes:
I would adjust the scale of the lightsaber depending on your preference. Also, Print the connectors slightly smaller than it says because they print very tight. The file with the entire lightsaber doesn't have a spinning switch, but if you print all the pieces separately the switch will spin. The lightsaber isn't to scale anyway because we don't have that info yet.
