by fiercedLight
Some supports are required though.
Put supports to thumbs, ears and neck.
Careful around neck because you wouldn't want to limit its movement. In my setting one for each connector prints well.
I didn't care for the back of the model since it is almost flat and I am new with those hinges and didn't wanted to mess with them. However I also included the full model in any case.
If you use cura I included the cura project that I printed with. It uses "Custom supports" and it might not work if you don't have it. Raft air gap might be an overkill. Check the settings before you print.
I printed the purple one with a raft, 0.28 mm default cura settings. Blue one is a prototype.
bitcoin addr: 3Gn7kpiPoqehnP5ReewrXuKeYUxpHrxfqm
