by Drazen, published
The original low poly bulbasaur model has a very small and shallow spot for a plant. I greatly enlarged this to allow more dirt and a healthier plant to grow. I suggest scaling the model up at least 200% if you want to keep a plant alive. I printed one at 2x, 3x and 4x scale The model shown in photos is 4x scale.
I also upgraded the drainage a little bit. The idea it to make bulbasaur a passable pot!
Printer: wanhao i3
Rafts: Doesn't Matter
Supports: No
Resolution: 0.3mm
Infill: 10%
Notes:
PLA, 3 shells, 1.5mm top, 1mm bottom
