This is my design of the sword of the witch-king of Angmar, I think it's pretty accurate. The blade it’s made in 3 pieces of 370mm with alignment points for easier gluing, it also has a hole for a M6 x 1000 mm rod in order to reinforce it.
The handle has recesses for M6 nuts, glue a nut on the two sides. Use one to screw into the M6 rod to keep the guard in place. For the pommel glue a hex head M6 x 20 and tighten it to the other nut on the handle.
I'll post photos once I finish printing it.
Supports:
Yes
Resolution:
0.2-0.1
Infill:
15%
Notes:
Print the guard at 0.1 layer, to get a better finish on the engraving.