by Aquabee
This is a remix from LSMiniatures, inspired by printthatthing, but his thing didn't print so I redid it. The white Hairy Einstein was printed scaled down 50% as a test, but I wouldn't scale it down that much as that makes the hairs and the surrounding support wall too thin and will either not stick while printing or break off easily while cutting. Lost lots of hairs due to that and also while cutting with a knife. I recommend using thin scissors instead. Also lost some of the moustache and all the eyebrows for the same reasons.You will also need to trim the moustache and eyebrows before blowdrying the hairs into position. And a final touch up trim of the back if needed.
I will print the full size and post photos soon. I am hopping that will come out much better.
Enjoy printing and would love to see photos of your hair styling technique in the comments.
Printer Brand:
FlashForge
Printer:
Rafts:
No
Supports:
No
Resolution:
0.2
Infill:
10% will do
Filament: any pla
Notes:
Print slow, and don't scale down too much.
