by ClassyGoat, published
Wild GEODUDE appeared!
The 3D model for this originated from this wonderful site that rips Pokemon models from the various games: http://roestudios.co.uk/project/3d-pokemon-models
But then I made it 3D printer friendly!
I welcome anyone to make improvements / remixes of this.
Pokemon Copyright Gamefreak/Nintendo
I printed this on a FlashForge Creator 1 (based off of the Replicator 1)
I used grey ABS and sliced with these settings:
No Raft
Exterior Support (YOU MUST USE SUPPORTS WITH THIS MODEL!)
10% Infill
0.2 mm Layer height
3 Shells
40 mm/s feedrate
55 Travel feedrate
230 degree temperature.
It took just under 3 hours to print with these settings.
