by Heref

This is a AT-ST model in 1:75. It prints in two parts. Just remove the supports and snap them together. Then you can rotate the head making pew pew sounds as you run down pesky Ewoks!

At 1:75 it is about the same height as the AT-ST included in Imperial Assault.
It goes along well with Kirby Downy's excellent AT-AT (the leg of which is shown in the right of the picture) at myminifactoryhttps://www.myminifactory.com/object/3d-print-detailed-at-at-17606

For simple support cleanup, print the Easyhead as shown with the back of the head resting on the build plate. However, if you want some more and finer details, print the Harderprint head with the bottom of the neck resting on the build plate, but be prepared for more challenging support cleanup.

The legs are still pretty thin, be careful when removing the supports!

Designed and printed on the M3D Promega.

4/10/2020 - cleaned us some issues in the hull. Added Harder Print Head.

Print Settings

Printer:

M3D Promega

Rafts:

No

Supports:

Yes

Resolution:

0.250

Infill:

10%

Filament_brand:

Soultech

Filament_color:

Grey

Filament_material:

PETG

Notes:

For easy printing use the Easyprint head as shown with supports, minimum support angle of 50 degrees. It is designed to print on a 0.5 nozzle. However, a 0.35 nozzle should bring out more of the detail. The image enclosed shows a print at 0.4 mm layers with the Easyprint head. For a finer head model, try the Harderprint head to get a better looking front, (the support removal will be more of a pain). The legs are still pretty thin, be careful when removing the supports!