by Evaken, published
Set of Pokemon Go keyrings.
I suggest scaling these down to 50mm wide on the X axis (width) to print.
If you DONT scale them, the back (black or white) is 2.5mm and the coloued bird part is 2.5mm wide. This will be useful for you to know when to switch filament.
I simply watched and waited, paused as soon as it started the bird, changed filament, resumed.
Updated 25/7/16: changed Instinct STL. Thickened some lines. Scale this model to 5mm Z-height
Disclaimer: I do not claim to own these logos at all, they are property of Niantic/Nintendo, and I strongly suggest you do NOT try to sell these designs once you've printed them.
Printer: Cocoon Create / Wanhao i3
Rafts: Doesn't Matter
Supports: No
Resolution: 0.15-0.20
