by bda56 

this started off as a grave train but now turned into a Land crawler cargo hauler.

there are a lot of files but i have tried to numbered them something logical.
it is all quite modular so you can mix things up but it was planned to have each section around 1' long.

011-relates to the lower end sections, including a selection of locomotive options.
note it might be necessary to remove some of the rivets along the side for a flush fitting of the tracks.
for the grave plates there is a small riser section you can put underneath to give the impression of it floating.
for the end connectors i have made it so you can flip them over so they fit flush with the next one in line.

012-relates to the middle of the lower section, you can leave this out for a short section or add more- its up to you.

the following parts are the engine section that can fit on top of the base unit.

020-relates to the door and rivets section for all the upper parts

021-is the front of the engine section, control

022-is the middle, power

023-is the end, engines.

i printed all my parts on an ender 3 pro with a 5% infill, most of it dose not need supports but the body section for 021,022,023 do as dose the 020 door.
the 011 end sections have 2 versions one needs supports while the others done.
with the exception of the control panels in 021 everything was printed at 0.3 layer height and no rafts where required.

note the crew, railings, gun rack, screens in the corridors and the radar dish on the roof where not 3d printed.

hope you have fun with this as i have enjoyed making it and have other plans to add to it down the line.