by akshay_d21
Please Note:
These models are not meant for commercial use in original or derivative form. The design is meant for personal use only. All original concepts and likeliness of the design are attributed to Disney.
All models print without supports.
Files for the main body/housing have been added in many variants in case you do not find the exact switches or electronic items that I have used here, to edit on your own accord.
Bill of Materials
1 Qty. of CR2032 3 Volt Lithium Battery
1 Qty. Optional small value resistor (200-500 Ohms) (Recommended)
1 Qty. High Knob 3P 2 Position 1P2T (1 Pole 2 Throw) SPDT Vertical Slide Switch, 0.5 Amp, 50V DC, 3 mm
Tracking fobs were devices used by bounty hunters to track their quarries. The bounty hunter would return the fobs after capturing their bounty as proof of capture. In 9 ABY, the Bounty Hunters' Guild handed out tracking fobs to its hunters. Mandalorian bounty hunter Din Djarin returned his fobs after capturing all of his quarries.
Post-Printing
Clean Up and Assembly
- Clean-Up may be necessary on the sleeve in the case your printer over extrudes. - After printing all the parts, insert the battery, the LED, the resistor and wire it to your switch or leave open if desired. - Assemble the parts to make it look as shown in the images.
