Fan art of Coco from Animal Crossing, model made by me. Base plate is two pieces so you can put NFC inside if you'd like.
My recommended procedure would be:
Print out everything
Remove any support material
Make sure the figure fits into the bottom piece of the base plate, don't glue yet
Sand any rough spots (I used 200 grit sandpaper)
(Optional) place NFC into bottom piece of the base plate, make sure it works before gluing pieces together
Glue figure and bottom piece of base plate together (I used super glue)
(Optional) clean, paint, and put a protective coating on your figure
Print Settings
Printer brand:
Prusa
Printer:
I3 MK3S
Rafts:
No
Supports:
Yes
Resolution:
0.1mm to 0.15mm
Infill:
5
Filament_brand:
Prusa Research
Filament_color:
Silver
Filament_material:
PLA