by craftos
All credit goes to the fantasitc work of Walkyrie222, check him out for further add ins and tip him for his hard work.
This is a remix, all i did was make it resin ready by joining a hole heap of it together, hollowed it and supported it. The only parts i didnt resin print was the bottom half of the centre and its front door/ramp. these were printed on FDM
Just because im a top bloke, i also added my supported files and bedplates to this upload. These are arranged for my anycubic Photon and you them at your own peril.
All up I think I would have used 250ml per plunderer and about 30hrs print time. you could most likely cut this down by combining plates, however I chose not to heavily stack my plates
Happy gaming
