by SdiaCamR
I required a female Pokemon Go trainer model for my wife, I couldnt find one anywhere so I made this.
The base trainer model was used as a base, I then set a standard pose, cleaned up the mesh in Meshmixer, reduced the polygons and added a necklace and Pokeball in one of her hands.
This model was only printed once, it printed ok but if I had to do it again I would scale it up a bit and reduce the layer height. I printed the model 13cm high and some of the fingers didnt print too well.
I also printed the model on its back, it would probably look better printed standing up
and benefit alot from more cleanup such as a small amount of aceton smoothing.
If someone were to send me a message and ask nicely I might be persuaded to upload more models with other poses and/or other features such as different hat/backpack.
Print Settings
Printer brand:
Creality
Printer:
Ender 5
Rafts:
No
Supports:
Yes
Resolution:
0.15
Infill:
5%
Filament_brand:
Geetech
Filament_color:
White
Filament_material:
PLA
Post-Printing
