by eXzez
Awesome bust that needs some minior tweaks for better Printing.
Fixed some the tentacles that to thin and have bad overhang degrees.
Now its fine and can be easier printed.
Also i have split the base and the sculpture in two parts, that is not necessary but it helps to save unnecessary filament for the supports.
Hopefully this model gets a bit more attention outhere.
Print Settings
Printer:
Artillery Sidewinder X1
Rafts:
No
Supports:
Yes
Resolution:
0.15
Infill:
0%
Filament_brand:
Extrudr PLA NX2
Filament_color:
Red
Filament_material:
Pla
Notes:
Atillery sidewinder X1 - Recommend Printer settings:
Layer height: 0,15
Walls: 3-5
Extrusion width: 0,5 @ 0,15 layer height (depends on the number of walls.)
Speed: 50 mm/sec. (PLA) (depends on the printing Material.)
Infill: 0 %
Fan speed: after first 5 Layer 80-100%
Slicer:
Craftware
Height of the entire Model of the Picture 30 cm.
Enjoy it and thanks for sharing this uniqe model.