by ThomasWilko
The idea for this model originated when viewing ibudmen's model:
https://www.thingiverse.com/thing:49480
I wasn't quite into his design and the mesh was a bit rough on that model, so I decided to make my own!
This model was created in Solidworks 2020 and the associated solidworks part is included in the downloadable files.
Tested on: Creality CR-10S Pro V2
Material: PLA - Red Copper
Infill: 10% (higher is recommended, perhaps ~20%)
Supports: Yes - for the horizontal hydroplanes only
Open to suggestions for changing the model, so leave a comment!
