by okMOK 

Reupload of my design because for some reason Thingiverse hates me and has messed up half of my uploads and is also preventing me from uploading other designs... :/

So please do search for my id okMOK on Cults3d and MyMiniFactory as I also upload stuff there.. especially now as Thingiverse is not working for me.

Please also consider supporting me on patreon or buy some of my models off cults3d to support my work. Sadly tipping via paypal does not work for me so that will not help but I do appreciate the sentiment.
Do also subscribe to my youtube channel, I know there isn't much there yet but I do have plans for that in the near future and could use the encouragement. Thank You!

Print Settings

Printer:

HEVO

Rafts:

Doesn't Matter

Supports:

Yes

Resolution:

0.15

Infill:

10%

Filament_brand:

Generic

Filament_color:

Pearl Red

Filament_material:

Doesn't matter

Notes:

Take special note of overhangs and bridge sections. Use supports smartly NOT blindly... a helpful advice....
So I printed the split model and glued them together. The artifacts and aberrations on the model in the picture was my attempt at finishing / acetone smoothing , etc. which went wrong and I gave up. The banding had something to do with my extruder and Z lead screws (older machine and old print) and I don't think these should appear on any of the newer and properly tuned machines also using better quality filament will definitely help. For these prints I was just testing stuff.
Oh! one more thing this model does not have any base to stand or balance on so it will not stand upright without using some support. you can try to glue it to some thing and it will hopefully work out, sorry I know I should have made a base with this :(

P.S. The full model has glasses on and the sliced model does not ..... yea my bad again. So Thoroughly check the print preview to see which file you can make work with your printer and settings.