by TobBot2
The pedestal and master sword are to the same scale. I used Cura to export as g-code and had to scale each model up by 4500%. After this, the sword came out to be about 8 inches long. Also, I put some foam at the bottom of the hole in the pedestal so the sword doesn't wobble around so much or chip away the paint. The grip is not included, I just painted it on afterwards.
Print Settings
Printer brand:
Creality
Printer:
Ender 3 Pro
Rafts:
Doesn't Matter
Supports:
Yes
Filament_brand:
hatchbox
Filament_color:
Orange
Filament_material:
PLA
Notes:
print so the sword is flat on the ground (though the bit at the handle will make it float a little, but with supports this will be fine).
