I wanted to print the ship from Outer Wilds but the model extracted from the game by Sandman0077 was too brittle, the outcome broke in multiple places and surface quality wasn't great. So I went ahead and remodeled it in Fusion 360.
I had to leave out small details (mostly the wires and ropes) and enlarge bits (mostly on the legs and feets). You could use wires or strings to replace them. I also broke it down in a bunch of parts that can be printed with a correct orientation and glued together.
I grabbed a rocky base made by Nick Gizelis as well (https://www.myminifactory.com/fr/object/3d-print-miniature-base-26-50mm-127548) and scaled it to add a little something to the whole print.
PS: Sorry for the bad paint job, I'm no good with brushes.
Print Settings
Rafts:
No
Supports:
Yes
Resolution:
0.12
Infill:
20%
Filament_brand:
Doesn't matter
Filament_material:
PLA
Notes:
Thrusters : Tree support works great
Body : The two planks that hold the rear are still brittle, print this part cockpit-side down so that they are not connected to any support
Legs : The little sticks connecting to the feet are still brittle, be careful when removing support
Antenna : For surface quality, this part is best printed sideways
