by evan25lee 

Model ripped from Seven Deadly Sins Grand Cross

Likely not possible to print on an FDM printer (Would love someone to prove me wrong though!), I highly recommend SLA.

I've printed this model at 100% size and 50% size, both worked great however, on both the balcony would often break off, on the 100% size one I only managed to get 1 to successfully still have the balcony.

THIS MODEL WAS NOT MADE TO BE EASILY 3D PRINTED AS IT WAS A DIRECT RIP FROM THE GAME. IT IS VERY UNLIKELY THAT THIS MODEL WILL WORK ON AN FDM PRINTER UNLESS YOU ARE PRINTING AT A VERY LARGE SIZE.

Fun fact: This is the hawks mama you see on the map between chapters.

Print Settings

Printer:

Elegoo mars

Rafts:

No

Supports:

Yes

Resolution:

0.05

Infill:

100%

Filament_brand:

Elegoo Standard Photopolymer Resin

Filament_color:

Grey

Filament_material:

Resin

Notes:

Not a print that would be possible on an FDM printer due to the amount of supports needed on fragile pieces. Would love to see someone prove me wrong.

Post-Printing

Generic SLA curing procedure

I washed my prints in a tub of Ethyl Alcohol and cured with a generic UV light on amazon. I used a solar powered turn table to rotate the print.
Like with most SLA prints you will likely see better results if you remove the supports BEFORE curing the resin, it will leave less marks in the surface of the print.

Obviously be careful with the small parts though don't feel like the print is ruined if that top balcony is gone, its a very difficult thing to keep working and if you are not printing at the normal size it is not even noticable.