by BlueLightNo1
Working Pokeball with button and hinge. I printed this on a CR6-SE.
Print Settings
Printer brand:
Creality
Printer:
CR-X
Rafts:
Doesn't Matter
Supports:
Yes
Resolution:
0.2mm
Infill:
15%
Filament brand:
Any, I used Hatchbox
Filament color:
Any, I used black
Filament material:
Any, I used PLA
Notes:
To assemble, you will need:
Super glue
Pen spring, cut about a quarter of the way down.
A toothpick
Print out the pieces at 100% scale. Align the latch on the button with the cutout on the top lid. Insert the button into the hole. Place spring in hole cut into button. Align hole in button stop with spring. Glue button stop onto inside of the top lid. Make sure to not glue the actual button or it will not work. Align the hinge pieces on each side. Push a toothpick through and trim to fit. Paint if desired.