by bryandtaylor
Everyone needs snow porgs! We got a lot of snow recently and I decided we needed a mold to make some porgs.
The model is fairly robust, and will take a while to print. I printed mine with PLA, four walls, 20% infill.
Print Settings
Printer brand:
Creality
Printer:
CR10S PRO
Rafts:
No
Supports:
Yes
Resolution:
0.2mm
Infill:
20%
Filament brand:
NA
Filament color:
NA
Filament material:
PLA
Notes:
I wanted the pivot pin to have a tight tolerance, so you'll probably have to clean up the holes and the pin a little. I ran a large drill bit BY HAND through one of the side pivot bars and the center pivot bar. I left the other side pivot bar a little tight so it will hold the pin without any glue.
