This is an accurate model of a Buck Rogers Starfighter / Thunderfighter from the 80th TV series "Buck Rogers in the 25th century". Complete with sliding canopys, retractable landing gear and two seats just as shown in the TV series.
Its made for 4" Action Figures and all parts are easy to print on an 20x20x20 printer.
It also can be used for Star Wars Action Figures from Hasbro.
The final model is 40x30x10cm, print time is about 40-50 hours for all parts, the longest print time is 18-20 hours for the back of the body.
Printing instructions.: (Very easy to print if you follow this suggestions)
Print Front and back body and the engines standing upright on the split face, no supports needed.
Print the two Cockpit parts in the same direction with supports "touching built plate only"
Print the landing gear and the cockpit panel in high quality. The cockpit panel also needs supports. Print the Landing gear without supports laying on the side which has small integrated supports for the hydraulic cylinder. The LG consists of two parts which print in place. Move the sky a little to break it free after printing.
Print the wings laying flat without supports
Legal stuff:
BY DOWNLOADING THE FILES FROM THINGIVERSE YOU AGREE TO THE FOLLOWING TERMS AND CONDITIONS:
The files are for private use only!
You are allowed to print parts from them for your personal use only!
You are not allowed to use this files or parts you printed with the use of this files of it in any comercial way!
If you are distributing Pictures from parts or models you build with theses files you are only allowed to to so if you are declaring the source of the design. You have to add a link to this thingiverse-thing in the description of your Fotos!
You are not allowed to copy or distribute them in any way!
You are not allowed to sell them or parts you printed from them or models you build with the use of this files!
