by fixumdude
This is my kit card interpretation of the TIE Defender.
Check out my other models printed giant sized featured on The 3D Printing Nerd
We love the Star Wars Kit Cards by benzz88 Edabot Nakozen and delman83
This was made to fit when printed on my homemade hypercube300 printer which is not the highest precision printer in the world, so you may have to adjust the holes, or use a little glue depending on how dialed in your printer is. Adjusting the z-scale slightly up or down without changing the x & y scale can help as well.
There are two versions included. One with the frame (sprue) for gifting and one with the parts only to save plastic if you just want to put it together for yourself. One wing center panel has a ring for hanging, or using as an ornament. Make sure that panel is on top if you are going to hang it up.
Printed card is 120mm X 120mm to fit on most printers.
Assembled Model is roughly 82mm X 63mm X 50mm.
Print Settings
Printer:
HyperCube300
Rafts:
No
Supports:
No
Resolution:
0.2
Infill:
20
Filament brand:
Hatchbox & Filacube
Filament color:
Gray
Filament material:
PLA
