An anime figure. She prints without a base, so be aware.
Print Settings
Printer brand:
Creality
Printer:
Ender 3
Rafts:
No
Supports:
Yes
Resolution:
200
Infill:
20
Filament brand:
PolyMaker
Filament material:
PLA
Notes:
Supports everywhere, angle set to 0 (so supports under every overhang). X/Y distance 0.5m, Z distance 0mm. The model has a lot of thin overhangs that like to snap off mid print, even with ample support.
Beyond that, Be aware of difficulties resolving fine detail. The one I uploaded should print well on an Ender 3with 0.15mm layer height, but you might be able to scale that down if you have a higher end printer.