This model has very fragile walls so be careful when removing it from the print bed. The indentations for the magnets in the faceplate are also very small so use a drill at a slow speed to slightly deepen them.
The magnets I used for this model were 4x2mm disk magnets. I used four at the top and four at the bottom of the face mask. Just superglue the magnets in place when they're in the correct orientation. There are no magnets in the jaw so the main helmet and jaw pieces can be glued together leaving only the faceplate detachable.
There is also enough space in the helmet to add some LED's or cosplay eye lights.
Print Settings
Printer brand:
Creality
Printer:
Ender 3
Rafts:
Doesn't Matter
Supports:
Yes
Resolution:
.15 mm
Infill:
20
