by acmbarber
The scale is about 270 to fit in with the X-Wing board game.
There is no mounting pin hole built into this model. I have used a small pair of magnets between the printed mounting pin and the engine section at the aft end. This is great as it allows the B-Wing to pivot to different angles.
What I changed in the remix:
1- completely rebuild the tail 'wing' and gun foot.
2-thickened and slightly shortened the side guns
3-added greebles to the wings, body, and cockpit
4-changes the pivot cap so that the rear engine section acts as the cap instead of the whole body being split.
I printed this on a resin printer. I needed to file the engine block to get a proper fit. The inside of the cockpit holding ring on the main hull needed filing as well. The hinges work well, but they are delicate. I have a micro-hand-held drill set to clean out the holes but that might not be necessary if your print is cleaner than mine.
I would dig seeing some other makes!
Print Settings
Printer brand:
Anycubic
Printer:
Photon
Rafts:
No
Supports:
Doesn't Matter
Resolution:
0.05
Infill:
20
Filament brand:
Eryone
Filament color:
Clear Blue
Filament material:
Resin
