Phase Pilot pauldrons from Titanfall. These are full size and designed to be attached to a jacket or webbing straps with zipties. It can be wired with 3mm LEDs, which also requires thin frosted plastic for light diffusion. The smaller parts should be affixed with superglue, and the larger parts require #4 wood screws. The four largest screw heads visible are real M5 flathead machine screws - these are ornamental and are not 3D models. This was a one-off build, so I never wrote any instructions. You will need to figure a few things yourself, but there is nothing complicated about it.
The largest part is about 184mm long. The file names include required quantities. Enjoy, pilots!
Print Settings
Rafts:
No
Supports:
Yes
Resolution:
200
Infill:
20
Filament brand:
Your favorite
Filament material:
PLA
