by Holmer92
Less supports and better joints since all joint surfaces is facing the bed except 1 and not supported that can leave edges. Only downside is that the arms and hands on the upper side are suffering from the supports, but could not see a better solution in this case.
Legs can be printed without supports, but a little sag will appear on the lower part of pants.
Body needs support inside of the mouth and some in the hair. I used a dot of support at the very beginning of the nose too.
Arms will need supports in the whole hand and a bit on the arm, if u decide to orientate the joint to the bed ofcourse.
The cubes may need to scale down or up. depends on the printers quality, thats why i left them loose and not attached to model.
Print Settings
Printer brand:
Creality
Printer:
Ender 3
Rafts:
Doesn't Matter
Supports:
Yes
Resolution:
0.12
Infill:
7
Filament brand:
Clas Ohlson
Filament color:
Grey
Filament material:
PLA
